My clutch basket was toast and I couldn't find any aftermarket one's and OEM was too dear.
I found on trademe a cheap Dr400 basket, So i did some reshearch and found that DR400's used the same plates and hub.
I took a punt and when it arrived it matched up except the drive gear was different.
So I drilled out the rivets and swaped over the backing plate.
I now have a mint basket for less then $50.
I will press in the new rivets tommorrow.
My spokes arrived yesterday and I laced them up this morning.
Painted hubs ( Satin Black ) with new bearings, Stainless spokes & new rims.
I was dreading the job but it turned out pretty easy.
Took a couple of hours to do all 4.
Trued up 2 of the rims this afternoon. Again not that hard if you have some paitence.
I need to swap out the front end on the 125 and put on the drum front end. The silver wheels are for the 125, the gold, 250.
The crank has been assembled with the new rod so might put the bottom end together tomorrow or do the front end.
All got to be done at some time.
Need to order a sproket for the 250 as well.