Now i have servised my forks, had a look at stack. It has only 2x22mm base washers, didnt take any off. But now i will test overfilled bladders
It isnt such a big deal if you dont have airscrew in youre fork cap and want to test this. i have the screw, but still didnt use it to fill bladder. Very easy...
You just fill fork like normaly, when you have taken air off the system, cap on, rod out, install rubber band tightly over bladder holes, push rod up and bladder will expand. Now take cap off slowly pull rod out and add oil sametime. Repeat untill you have enough overfill. I did it two times and then I let some oil out from bleed screw.
Now just hoping that i can go testriding.
B