Author Topic: I need some help I have a cr250 (Read 2063 times)

codyta94 · « **on:** May 06, 2013, 01:55:11 AM »

I was replacing the piston in a 2001 cr 250 and I noticed the crank was fully submerged in atf fluid. If this is the main crank seal how hard is it to replace and I have a parts bike xan I just pull the seal off that one and use it or what?

motoxr377 · « **Reply #1 on:** May 06, 2013, 02:01:38 AM »

Do you like your bike? Buy a new seal.

codyta94 · « **Reply #2 on:** May 06, 2013, 03:52:49 AM »

Im kinda tight on money so anything will help

cnrcpla · « **Reply #3 on:** May 06, 2013, 01:32:25 PM »

If the parts bike has the exact same seals than yes, you can pull those and replace them (provided they are in good shape and not worn out either).

SachsGS · « **Reply #4 on:** May 06, 2013, 03:06:41 PM »

I would use a new seal(s) and would also check the crank main bearings for wear.

factoryX · « **Reply #5 on:** May 06, 2013, 05:11:42 PM »

might as well change the mains while you're there.

News:

Author Topic: I need some help I have a cr250 (Read 2063 times)