Coming Soon
Home > Forum


Author Topic: TPI  (Read 7405 times)

0 Members and 1 Guest are viewing this topic.

Offline eprovenzano

  • Professional
  • *****
  • Posts: 617
    • View Profile
Re: TPI
« Reply #15 on: July 16, 2019, 07:42:58 AM »
Flettner has anyone ever called you a mad scientist...   ;D
Eric Provenzano
2019 KTM 300 XCW TPI
2000 KTM 300 EXC (Son's)
2001 KTM 380 EXC
Sold 1991 KDX 200... fun play bike
Sold 1999 KX250
Sold 1999 YZ125 (son's)
Sold 2001 Yamaha TTL 125 (son's 1st bike)
Sold but never forgotten 1974 Honda Elsinore CR250M
Sold 1974 Honda Elsinore CR125

Offline Flettner

  • Junior
  • **
  • Posts: 50
    • View Profile
Re: TPI
« Reply #16 on: July 16, 2019, 11:40:53 PM »
Flettner has anyone ever called you a mad scientist...   ;D

I've been called worse ;D
« Last Edit: July 16, 2019, 11:42:50 PM by Flettner »

Offline Flettner

  • Junior
  • **
  • Posts: 50
    • View Profile
Re: TPI
« Reply #17 on: August 27, 2019, 09:03:21 PM »
All the gears shown earlier are inside the this case. Bob weight and kick start gear / spring etc. Its all ended up a bit wider than I expected but too bad just needs to run now. This is the 360 with mk2 injection. Although this case look bulky it all machined from blocks of 6061, thin, so it all weighs bugger all.
Kick start is machined from a piece of 7075 block. Worked out nice in the end.

Offline Flettner

  • Junior
  • **
  • Posts: 50
    • View Profile
Re: TPI
« Reply #18 on: August 30, 2019, 12:47:56 AM »
See that nice 7075 kick start. First kick and it split in half. Bugger, O well ill build another in steel. 4140, and get it nitrided. In steel I can make it thinner.