Gas Gas vs. TM

[TMKIWI]

There are lots of Gasser's over here. I see more and more every ride.
TM's , well mine is the only one I have seen.
Did not stop me buying it.

[TotalNZ]

There are lots of Gasser's over here. I see more and more every ride.
TM's , well mine is the only one I have seen.
Did not stop me buying it.

i've seen couple other steel frame models down this way but mines the only alloy frame that i know of. when i bought mine it was the only 300 mx that had been imported to NZ

[TotalNZ]

Gasgas makes an awesome woods bike.They tend to be a shade heavier due to the fact,I think,that they're overbuilt in some areas-always a good thing imo.As for the TM,I'd like to say it's a pretty bike but that would go to TMKIWIS head
I will say the left fork sticker is on upside down.Damn eyeties.

I had the same fork sticker issue, whats up with that. lets down the finish i reckon

[MyckMcClung]

I got to ride the new Gas Gas 250 Enduro back in November, in Maplesville, Alabama, It was awesome!! However the bar bend is too straight for my tastes, I would replace it with a cut down CR-Hi immediately . I also tested it in jeans w/out my knee braces and noticed the radiator shrouds have a ridge on them that was very uncomfortable to my bare knees, I doubt this would be any sort of an issue with braces, but it should be noted for those who don't wear them.