16
Open Forum / Advice on bodywork and panel beating
« on: June 23, 2013, 08:02:59 PM »
Hi guys, this will be a bit of an odd post for this site but its the only forum I'm on and you all seem fairly knowledgeable people so here goes.
I've been working on restoring an old International tractor and now need to create some new mudguards and doors, the problem I'm having is that the mudguards curves on two axis.
Unfortunately my camera is broken at the minute and this is the only photo I have of it, you can see what I mean though about the mudguards.
Thanks in advance guys, your advice is always appreciated.
I've been working on restoring an old International tractor and now need to create some new mudguards and doors, the problem I'm having is that the mudguards curves on two axis.
Unfortunately my camera is broken at the minute and this is the only photo I have of it, you can see what I mean though about the mudguards.
Thanks in advance guys, your advice is always appreciated.