Messages

1

Technical / Air/Fuel mixture screw??

« on: June 04, 2012, 01:54:04 PM »

will do, thx man... what do u mean the throttle stop screw? r u talkin about the idle speed screw?

2

Technical / Air/Fuel mixture screw??

« on: June 04, 2012, 03:23:33 AM »

that was a lil confusing lol

3

Technical / Air/Fuel mixture screw??

« on: June 03, 2012, 02:03:43 PM »

ok so i closed my air fuel mixture screw and now im not sure where its supposed to be set... any tips on adjusting it? what difference does it make?

4

Technical / How do I slow down my idle?

« on: June 02, 2012, 10:44:46 PM »

ya i got it fixed 

5

Technical / cr125 idle problem

« on: June 02, 2012, 10:43:32 PM »

ok i got it... my jet needle wasnt going all the way down so i stretched the cable a little bit.. THX FOR THE HELP ANYWAY!!!     

6

Technical / How do I slow down my idle?

« on: June 02, 2012, 08:54:37 PM »

GOT IT  With the exhaust leak and a small but noticeable air leak between the carb and reeds... I'm disappointed I didn't notice it. The clamp was on tight, but something happened that prevented a good seal. All set now, thanks for the help guys 

what do u mean exhaust leak? like the gasket/o-ring was messed up?? when i was looking at my bike when it was running with a high idle there was some exhaust smoke coming out from where the cylinder and exhaust pipe meet. 

7

Technical / cr125 idle problem

« on: June 02, 2012, 08:41:30 PM »

i dont think its the carborator.. every thing works fine. i probly have an air leak somewhere. i tried closing up the air screw on the carb and that didnt even do it... i might just take it to the shop.... ((((


nice signature btw!!!

8

Technical / cr125 idle problem

« on: June 02, 2012, 05:33:35 AM »

lol what do u mean slide bottoming? i dont know very much about carbs...

9

Technical / cr125 idle problem

« on: June 02, 2012, 03:48:21 AM »

what do u mean, under a load?

10

Technical / cr125 idle problem

« on: June 02, 2012, 03:13:36 AM »

i just rebuilt my 2000 cr125 and when i start it, it idles really high. ive cleaned the carb, put it back together the way my manual said, i even took the idle speed screw almost all the way out... PLEASE HELP!!!!