1
Technical / yz 125 top end rebuild question
« on: July 30, 2013, 07:59:57 PM »
ok thank you!
News:
Like the Phoenix rising from the ashes Two Stroke Motocross is reborn!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Technical / yz 125 top end rebuild question
« on: July 30, 2013, 07:05:28 PM »
yes i have heard alot of good things about millenium so i would probably take it there if anywhere. after the cylinder is replated do you have to remove any burs or is it ready to be dropped back onto the engine. thanks everyone for helping me out.
3
Technical / yz 125 top end rebuild question
« on: July 29, 2013, 05:26:01 PM »
sorry for the noobish questions but what would it look like if it still had the plating vs not having any plating left.
4
Technical / yz 125 top end rebuild question
« on: July 29, 2013, 05:09:59 PM »
ok thanks alot !.. it has 100 hours on the top end too 
5
Technical / yz 125 top end rebuild question
« on: July 29, 2013, 04:43:18 PM »
i am rebuilding my yz 125. but i am confused what size piston to get. i know the standard size is 54 mm but do you have to go one size larger like 54.5 mm because the cylinder walls wear down? If someone could reply with help asap that would be great!
Pages: [1]