1
Technical / Re: stuck in 1st
« on: August 03, 2011, 06:25:08 PM »
OOOOOoookey doke. This problem hopefully solved. It looks as though a dowel pin (or a bushing) fell in there and stuck between a gear. I split the case and found it on the left side. The microfiche (http://www.motosport.com/dirtbike/oem-parts/HONDA/2001/CR125/CRANKCASE) (36,37) says there's only two dowels for the case half to fit on, and I believe I have both intact and functioning in their respective places. The other problem is this: I went into the clutch side first to check the shifting linkage and the kickstart gear that goes below the gear the kickstart is attached to has a copper type bushing and it pushed out about halfway and is peened over and mashed. On the back of the clutch hub there is minimal rub from it or from the "dowel pin". Now the big question is....is this a mystery dowel pin or is this part that looks verrry similar to a dowel or is it a bushing off of something?
On the microfiche I can't seem to order just the kickstart gear bushing, wtf, do I gotta get the whole gear?http://www.motosport.com/dirtbike/oem-parts/HONDA/2001/CR125/KICK-STARTER-SPINDLE It's gear #2, the idler, is the bushing "built in".? That's not my main concern, its these freakin extra parts, and in this case this dowel/washer! I cant find where else a dowel would go....any ideas on any bushings that look very similar to a dowel, chamfered on the end the same, bend and damage much like a dowel would go? Thanks!
On the microfiche I can't seem to order just the kickstart gear bushing, wtf, do I gotta get the whole gear?http://www.motosport.com/dirtbike/oem-parts/HONDA/2001/CR125/KICK-STARTER-SPINDLE It's gear #2, the idler, is the bushing "built in".? That's not my main concern, its these freakin extra parts, and in this case this dowel/washer! I cant find where else a dowel would go....any ideas on any bushings that look very similar to a dowel, chamfered on the end the same, bend and damage much like a dowel would go? Thanks!