Messages

1

Technical / Clutch will not engage.

« on: December 05, 2012, 03:10:58 AM »

Before I replaced the parts

2

Technical / Clutch will not engage.

« on: December 04, 2012, 02:55:26 AM »

the cable is good.The clutch pushes out. But when it does it disengages it does unevenly. It seems like one side pushes out farther than the other.

3

Technical / Clutch will not engage.

« on: December 04, 2012, 01:58:33 AM »

It surges forward. Sorry I was under the impression That when you pull in the clutch lever you are engaging the clutch
 

4

Technical / Clutch will not engage.

« on: December 02, 2012, 11:40:55 PM »

I have not changed the springs yet and I used the fluid that the manual specified. Thanks for all of the advise. I'll try these ideas and keep you updated.

5

Technical / Clutch will not engage.

« on: December 02, 2012, 02:12:32 AM »

I have a 98 Honda cr125. I bought it as a basket case. After getting it running I tried to take it on a test drive but the clutch will not engage causing the bike to jerk forward as if I put it in gear without using the clutch. I have replaced the cable, clutch plates, friction plates, and even adjusted the cable and it still will not engage. Also I would pull in the clutch with the clutch cover off and it looks like one side of the clutch doesn't move as far as the other. Any thoughts?