Messages

1

General Two Stroke Talk / YZ360 biuld !!!!!

« on: November 26, 2012, 04:10:10 PM »

2

General Two Stroke Talk / YZ360 biuld !!!!!

« on: October 26, 2012, 06:51:38 AM »

3

Photos & Videos / YZ 360 Aluminum Frame

« on: October 25, 2012, 06:29:56 AM »

SMP every time i see your bike i want to get mine done more.

4

General Two Stroke Talk / YZ360 biuld !!!!!

« on: October 25, 2012, 06:23:04 AM »

5

General Two Stroke Talk / YZ360 biuld !!!!!

« on: October 25, 2012, 06:20:34 AM »

 had to have the steal sleaves that go into the back of the block opened up to fit the larger swing arm bolt. moved the lower mounts. the hard part was the front mounts. its very tight . when i set the engine i set it for the 94 pipe to fit.

6

Vintage Two Strokes / First Ride Impression 1985 RM125

« on: October 24, 2012, 07:59:54 PM »

 i had an 85 . ported that thing till i could cut my self on the knife edging . bike was fast would run with 250's . to bad the guy that rebiuld the crank never trued it right. it would open the seal and suck air and lean out . burnt up 3 topens then sold it. then i found out it was the crank . wish i still had that bike.

7

General Two Stroke Talk / YZ360 biuld !!!!!

« on: October 24, 2012, 07:50:03 PM »

this is the look im after . 70's yz360 meets early 80's yz meets Ohlins 360.

8

General Two Stroke Talk / YZ360 biuld !!!!!

« on: October 24, 2012, 07:24:03 PM »

 ive been posting this biuld on thumper talk . but i know i should be posting it here . so ill try to get everyone up dated.

 i have a 1991 yz250 engine with a Ohlins 360 big bore kit . im installing a wr trans and putting the whole thing in an 05 and newer two stroke frame.

here im fitting the 360 into the frame to see what need to be done to make it work .












here the frame has been welded and i have some yellow plastic on it . engine fits nice but it very close to the tank. using a bolt insted of one of the studs will fix that .



here is some art work i did . i really want this to have a 1970's yz360 look

9

Photos & Videos / YZ 360 Aluminum Frame

« on: December 31, 2011, 02:05:19 AM »

 i dont know if you know but noleen j6 has the paper work for the 360 kit . they can send it to you or emal it to you, it has jetting and gearing in it .

10

Photos & Videos / YZ 360 Aluminum Frame

« on: November 14, 2011, 03:00:22 PM »

I would like to call and talk to you about your bike. I'm building a Yz360af . I'm using an 05 Yz 250 for the build . You can't put a stock 250 cylinder back on the bike . The 360 has a long rod . Send me your phone number chevelleracer@AOL.com . I'm dieing to hear how it runs .