1
Technical / Re: 08 YZ 250 popping out of gear
« on: May 21, 2011, 07:27:43 PM »
Great, thanks I will give it a shot and thank you guys for the feedback
News:
Like the Phoenix rising from the ashes Two Stroke Motocross is reborn!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Technical / Re: 08 YZ 250 popping out of gear
« on: May 21, 2011, 11:09:53 AM »
It has been happening in 3rd. 1st and 2nd are fine and once it starts happening in 3rd I don't shift up I just let off and idle it back to the truck. Is there anything else that could cause this before I split the cases again? I change the oil every2-3 rides but ride in the sand a lot so Im sure the gearbox takes more abuse than normal. Thanks for the advise
3
Technical / 08 YZ 250 popping out of gear
« on: May 20, 2011, 09:11:33 PM »
Has anyone had any problems with YZ 250's popping out of gear. I have replaced the shift forks, all the gears looked good and all clutch components have very little time.
6
General Two Stroke Talk / just found this on thumpertalk
« on: June 29, 2010, 07:33:54 AM »
I came across this post on thumpertalk and got a kick out of it
http://www.mxboards.com/forums/download.php?id=48
http://www.mxboards.com/forums/download.php?id=48
8
Photos & Videos / Leatt Brace Decals
« on: May 06, 2010, 04:54:30 PM »
Just finished up some leatt brace decals let me know what you think
10
Technical / Re: Seat Cover and graphics
« on: April 27, 2010, 02:42:58 PM »
For the graphics I would try to stay away from the windex unless its a tough piece to line up. The windex puts more bubbles under the graphics. Good Luck
Pages: [1]