Messages

1

Technical / Clutch push rod assembly not working

« on: July 13, 2013, 09:01:01 PM »

Disregard, I just didn't tighten the cable enough.

2

Technical / Clutch push rod assembly not working

« on: July 13, 2013, 06:31:16 PM »

Cleaned and lubed my clutch cable and nothing now it's not working. The assembly can move when I do it manually but won't spring back on its own. Bike is an 05 yz250

3

General Two Stroke Talk / The REAL inside the Outdoors

« on: June 28, 2013, 03:55:51 PM »

[/quote]

Shagging.
[/quote]

I'm sure MX has their groupies too!

4

General Two Stroke Talk / The REAL inside the Outdoors

« on: June 28, 2013, 01:38:58 AM »

Like someone said above, how the big teams treat you. If you asked a favor would they help? Do they invite the privateers to bbq that Friday night? Things like that.
Don't know if you'll put it out or not but what teams are the nice guys and what teams are the ****s?
Great question for you to ask of the bench racers, can't wait to read about it. Love hearing the small things people outside of the teams never know about. Brings up my next question. What is the one thing that goes on that people never hear about unless you're in the pits.
Thanks

5

General Two Stroke Talk / Best Pipe to Offset Losing Top End after Low/Mid Porting

« on: October 30, 2012, 07:06:55 PM »

The bike is an '05 yz250.  All stock engine except I had my porting done by Eric Gorr for low to mid.  Obviously I lost some top end which was expected and I'm running a stock pipe.  Talked with Eric this morning and he said adding an aftermarket pipe for top end would not cancel out the bottom end porting.  So my question is has anyone had low/mid porting done and added a pipe to get some of the top end back.  I'm thinking DEP, Pro Circuit, FMF, etc.  Just seeing if anyone has any experience with this.