1
Technical / okay, yz250 float level
« on: September 17, 2011, 05:34:59 PM »
Okay I guess I am at a loss. The manual says the float level should be at 5.5mm-7.5mm, yet it still pisses fuel out over flow when set there. When I look up 38mm pwk float level, everyone and third cousin sets it at 15-17mm
http://www.carbparts.com/keihin/needles_tuning/jetting_your_carb.htm
But when I do this it doesn't look right but it stop pissing fuel... so wtf.
http://www.carbparts.com/keihin/needles_tuning/jetting_your_carb.htm
But when I do this it doesn't look right but it stop pissing fuel... so wtf.