1
For Sale / CR500 part out! tons of awesomeness! everything!
« on: February 24, 2013, 01:19:20 AM »
News:
Like the Phoenix rising from the ashes Two Stroke Motocross is reborn!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
For Sale / CR500 part out! tons of awesomeness! everything!
« on: February 24, 2013, 01:05:27 AM »
lowered shock
3
For Sale / CR500 part out! tons of awesomeness! everything!
« on: February 24, 2013, 12:57:46 AM »
4
For Sale / CR500 part out! tons of awesomeness! everything!
« on: February 24, 2013, 12:51:50 AM »
all parts located in 12514, ny. i can meet you in person or ship at buyers expense.
all prices do NOT include shipping
fmf gnarly pipe 89-01 cr500. $100 small clearance dent to clear the front ice tire (bike was lowered 4" for ice racing)
mint aluminum radiators from 92 cr500 brand new moose rad cap $100 comes with hoses shown in picture
cr500 kickstart $50
cr500 rear shock, lowered for ice racing $60
89 cr500 rear shock stock height $50
complete rear brake setup from 92cr500. master cylinder is from an 07 xr650l and brake lever is brand new. new pads, only used for a few ice rides this season. $120
cr500 reed cage and intake boot $40
almost new side number plates, white, $50 for both
cr500 seat normal height, aftermarket seat cover $75
92 cr500 subframe/airbox $75
92 cr500 frame, ignition mounts modified to fit PVL coil, steering kneck modified to have adjustable angle for flattrack/ice racing. comes with triple clamps that fit conventional honda forks. adjustable rake from 17 degrees to 27 degrees currently set at 24 degrees$250
89 cr500 gas tank. fit my 92 frame no problem. so id say it should fit 89-01. $75
cr500 radiator shrouds, fit my 89 tank $50
white cr500 rear fender, never seen dirt, a month old. $20
all prices do NOT include shipping
fmf gnarly pipe 89-01 cr500. $100 small clearance dent to clear the front ice tire (bike was lowered 4" for ice racing)
mint aluminum radiators from 92 cr500 brand new moose rad cap $100 comes with hoses shown in picture
cr500 kickstart $50
cr500 rear shock, lowered for ice racing $60
89 cr500 rear shock stock height $50
complete rear brake setup from 92cr500. master cylinder is from an 07 xr650l and brake lever is brand new. new pads, only used for a few ice rides this season. $120
cr500 reed cage and intake boot $40
almost new side number plates, white, $50 for both
cr500 seat normal height, aftermarket seat cover $75
92 cr500 subframe/airbox $75
92 cr500 frame, ignition mounts modified to fit PVL coil, steering kneck modified to have adjustable angle for flattrack/ice racing. comes with triple clamps that fit conventional honda forks. adjustable rake from 17 degrees to 27 degrees currently set at 24 degrees$250
89 cr500 gas tank. fit my 92 frame no problem. so id say it should fit 89-01. $75
cr500 radiator shrouds, fit my 89 tank $50
white cr500 rear fender, never seen dirt, a month old. $20
5
For Sale / parts or whole worked CR500 :(
« on: February 18, 2013, 12:28:09 AM »
well last fall i decided to build an ice bike. spared no expense.
its a 1989 cr500 engine, in a 1992 frame.
engine just completely done. maybe 2-3hrs on it.
bored on its 1st over. wiseco piston, professional port and polish on the cylinder.
the head was also machined and the builder said the squish is right at 60 thousandths (i will have to verify with him, i am not an engine builder and if that measurement sounds rediculous it could be off.)
anyway its easier to say it has slightly more compression then stock.
has a 38.5 mikuni flat slide carb. BRAND NEW PVL ignition.
the bike is lowered 4" and the frame has been modified to have adjustable steering angle.
this bike is beautiful but now on to the bad part.
yesterday (2/17) i was at the ice races and when i went to start my bike for the second practice the kickstart shaft decided to walk right out of the case. cracking the right side case and the clutch cover.. which was brand new.
TONS of brand new parts and let me tell you... this thing ran like a raped ape. i have no money left to put into this thing so i have to pass it on to make up for what i have lost. its a sad day.
asking $1600 as it sits with the stock wheels. $1500 if i keep the forks which are old conventional forks anyway. also the stock ride height rear shock will be included. ICE FENDER, and ice tires/wheels not for sale.
email ajconforti1 AT yahoo.com or call/text 845-389-8914 bike is located in clinton corners ny
its a 1989 cr500 engine, in a 1992 frame.
engine just completely done. maybe 2-3hrs on it.
bored on its 1st over. wiseco piston, professional port and polish on the cylinder.
the head was also machined and the builder said the squish is right at 60 thousandths (i will have to verify with him, i am not an engine builder and if that measurement sounds rediculous it could be off.)
anyway its easier to say it has slightly more compression then stock.
has a 38.5 mikuni flat slide carb. BRAND NEW PVL ignition.
the bike is lowered 4" and the frame has been modified to have adjustable steering angle.
this bike is beautiful but now on to the bad part.
yesterday (2/17) i was at the ice races and when i went to start my bike for the second practice the kickstart shaft decided to walk right out of the case. cracking the right side case and the clutch cover.. which was brand new.
TONS of brand new parts and let me tell you... this thing ran like a raped ape. i have no money left to put into this thing so i have to pass it on to make up for what i have lost. its a sad day.
asking $1600 as it sits with the stock wheels. $1500 if i keep the forks which are old conventional forks anyway. also the stock ride height rear shock will be included. ICE FENDER, and ice tires/wheels not for sale.
email ajconforti1 AT yahoo.com or call/text 845-389-8914 bike is located in clinton corners ny
Pages: [1]