Messages

1

Technical / 1998 Honda cr80

« on: November 20, 2013, 03:08:29 PM »

its tin. not rubber. am I suppose to have a rubber one too. according to the picture at the shop I just need  the tin. I didn't see anything with rubber in the picture or on my bike when I took it apart. I know these bikes had problems with this area of the pipe spitting crap onto the motor. so there might be an aftermarket upgrade but I haven't found one online yet

2

Technical / 1998 Honda cr80

« on: November 19, 2013, 01:37:54 PM »

the o ring I got from the Honda store doesn't completely rap around the muffler piece by the top end with three allen screws. there is a gap when it is on.. should it be a complete rap around?

3

Technical / 1998 Honda cr80

« on: November 19, 2013, 03:23:59 AM »

got everything change out the o ring needed to be replaced as well. started it up. it was leaking by the o ring. so now I have to see if I flip the o ring so the opening part of the o ring is on the bottom will work out better. plus I am trying to set the carb just in case its rich in jetting. any tips will be appreciated

4

Technical / 1998 Honda cr80

« on: November 11, 2013, 02:37:00 AM »

thanks for the help

5

Technical / 1998 Honda cr80

« on: November 10, 2013, 09:12:40 PM »

im trying to take three 5mm allen nuts off the exhaust. got two off but when I try the last one on the clutch side the allen wrench hits the frame. when I go threw the front with the t handle I cant get a good grip because of the exhaust pipe. any ideas? trying to change the gasket because its spitting fuel on my bike and so I can clean the exhaust pipe with a heat gun.