Messages

841

Technical / Re: Putting a silencer on

« on: January 07, 2011, 05:04:20 AM »

"F" a shorty. You should've invested in the Q. Make your smoker quiet. It just reinforces that we as two stroke fans actually care about the future of the sport, whereas the noisy 4 stroke dopes, only care about instant gradification.

842

Technical / Re: Any new ideas to keep mud from sticking under your fenders, etc.?

« on: January 07, 2011, 04:57:37 AM »

Turtle Wax Extreme Tire Shine, it also works well for detailing cables, hoses, rubber dust covers, and  makes old plastic look new, however
if you get it on your tire contact surface, seat, grips, foot pegs or any controls it's turns into ice as soon as it gets wet. So spray it on a rag generously and wipe it onto the surfaces you wish to treat. re-apply every 3 washes.

843

Technical / Re: Some help on leaning out my YZ250 please?

« on: January 07, 2011, 04:44:20 AM »

you might also have a leaky crank seal if you're oil fouling, look into that as well.

844

Technical / Re: Some help on leaning out my YZ250 please?

« on: January 07, 2011, 04:43:31 AM »

where is it rich? top. Mid, or bottom? if it's on the top drop a main jet size
in the middle, lower the clip on the needle, bottom drop a pilot size.
Duh,

845

Technical / Re: Big bore smoker chunking out new Dunlop M51's

« on: January 07, 2011, 04:41:11 AM »

are you running an 18 or 19 rim? is the tire a 130/18 or 120/19? try the M31.   and groove the center knobs horizontally w a tire knife. 13lbs. and maybe roll on the power a little slower, lol.

846

Technical / Re: KX125 Exhaust help

« on: January 07, 2011, 04:32:56 AM »

that was 9oz

847

Technical / Re: KX125 Exhaust help

« on: January 07, 2011, 04:32:15 AM »

FMF gnarly pipe, repack you turbinecore, Vforce 3 reed block, or Moose torque spacer and new reeds, you might also want to add a little wieght toi your fly wheel. (oz should be good for moto.. It'll give you a ton of bottom, almost like, dare I say, a fourstroke 250, and still rev out to the moon. you should also have your suspension serviced.

848

Technical / Re: What two stroke pre mix is best?

« on: January 07, 2011, 04:27:00 AM »

I ran Klotz for years, then due to the economy and much success using thier other products, switched to Lucas after my last rebuild, I think it's a semi synthetic, I'll have to double check to make sure, . quart for $6 at O'Rielys Auto Parts. the spooge is not super sticky, like most other brands, washes right off w Shout and a hose, actually kinda smells like castor and doesn't smoke. I'll let you know how the top end looks next re ring.

849

General Two Stroke Talk / Re: Show us your ride.

« on: January 07, 2011, 03:57:37 AM »

hmm, image not as large as I hoped. I might need some help with the hypertexting option. will get back to it when I have more time.

850

General Two Stroke Talk / Re: Show us your ride.

« on: January 07, 2011, 03:56:22 AM »

Hi Everyone, just found this site while researching the new Maicos. I am freakin stroked there are still so many dedicated two-stroke die hards left out there. All of my bikes are two strokes with the exception of my DualSport, but I think the DR truely believes it's a reincarnated 1980 RM500,lol. here is my current ride