1
For Sale / WTB - A KDX 220 top end with head , decent condition
« on: March 01, 2013, 01:32:44 PM »
I'm looking for a 2000 and up KDX-220 top end , cylinder with head.
Thanks
Thanks
Be sure to find us on fb,Twitter and YouTube!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
yes you'll notice it, but make sure you check the squish clearance. if someone has been in there before they may have altered it. i wouldnt go tighter than .045"-.050" with an older crank. with a new crank i have run it as tight as .030"
It's not uncommon to eliminate the base gasket on a 2t.If you were going to do it,I'd go with either 1194 or 1211
http://www.threebond.co.uk/PRODUCTS/ThreeBondSealants/LiquidGaskets/tabid/229/Default.aspx
I expect the low end difference would be negligible though.
I see you have a 220 as well.As you are no doubt aware,the 220 runs a smaller carb than the 200 and therefore has better low end.For the couple minutes it takes,I'd swap carbs and see where you're at-with the base gasket in place.