Two Stroke Motocross

Two Stroke Motocross Forum => General Two Stroke Talk => Topic started by: codyta94 on May 06, 2013, 01:55:11 AM

Title: I need some help I have a cr250
Post by: codyta94 on May 06, 2013, 01:55:11 AM

I was replacing the piston in a 2001 cr 250 and I noticed the crank was fully submerged in atf fluid. If this is the main crank seal how hard is it to replace and I have a parts bike xan I just pull the seal off that one and use it or what?

Title: I need some help I have a cr250
Post by: motoxr377 on May 06, 2013, 02:01:38 AM

Do you like your bike? Buy a new seal.

Title: I need some help I have a cr250
Post by: codyta94 on May 06, 2013, 03:52:49 AM

Im kinda tight on money so anything will help

Title: I need some help I have a cr250
Post by: cnrcpla on May 06, 2013, 01:32:25 PM

If the parts bike has the exact same seals than yes, you can pull those and replace them (provided they are in good shape and not worn out either).

Title: I need some help I have a cr250
Post by: SachsGS on May 06, 2013, 03:06:41 PM

I would use a new seal(s) and would also check the crank main bearings for wear.

Title: I need some help I have a cr250
Post by: factoryX on May 06, 2013, 05:11:42 PM

might as well change the mains while you're there.